Prometheus-BME280-exporter

A prometheus exporter for a BOSH BME280 sensor, this time, written in go :green_heart:

Wiring the sensor

image

VIN, GND, SCL and SDA are the notations on the sensor board of the GYBME280 sensor.

For testing, you can install i2c-tools with the following command: sudo apt-get install i2c-tools and then check with i2cdetect -y 1, if the sensor is connected to either 0x76 or 0x77 address:

$ i2cdetect -y 1
     0  1  2  3  4  5  6  7  8  9  a  b  c  d  e  f
00:          -- -- -- -- -- -- -- -- -- -- -- -- --
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
70: -- -- -- -- -- -- 76 --

Running the exporter

After you’ve successfully mounted the sensor, you have to enable the I2C interface. You can either use sudo raspi-config and enable it in the UI or add the following to the `/boot/config.txt

pi@raspberrypi ~ $ sudo vim /boot/config.txt`

Add to the bottom;

dtparam=i2c_arm=on
dtparam=i2c1=on

A reboot of your Pi is required to take changes effect. Run the exporter with:

docker run -it -v /dev/i2c-1:/dev/i2c-1 --privileged -p 9123:9123 lukasbahr/prometheus-bme280-exporter:74b2a86 --loglevel=info

The privileged mode is currently required to grant access to the i2c device. Not the best solution but ad-hoc the first working one.

Because Kubernetes is noice

For a quick-start to run the exporter in a kubernetes cluster, refer to the kubernetes/daemonset.yaml. The daemonset is configured to run on the nodes of the cluster with a nodeSelector enabled. If you’ve installed the sensor on all nodes, leave it empty. For a more customizable setup, refer to the helm chart.

Further reading

Rebiulding

Open ToDos